symptoms
| failure reasons
| processing method
|
no or little water | a) pipe debris is blocked b) improper installation | a) remove the bubble machine, open the handle to check the water flow, clean the filter and reinstall it. b) check if the water supply hose is twisted.
|
continuous dripping or leaking after closing
| spool seal failure | replace a valve plug seal or valve plug |
after dripping or leaking after closing, it will stop dripping for a while and then | faucet bubbler blocked by magazine | remove the bubbler, clean the filter and reinstall it |
water leaks at the rotation of the outlet rod | sealing ring, o-ring failure | replace seals and o-rings
|
there is water leaking under the table | a) leaking water from the faucet inlet hose or joint b) leaking water from the "o" rubber ring on the contact surface of the faucet and the sink
| a) replace the water inlet hose or joint b) replace the "o" rubber ring |
noisy faucet water | the water pipe or faucet is not fastened or the water pressure is too high | adjustment |
the faucet filter is washed out by water | outlet filter rust card | replace the nozzle filter |
the outlet rod rotates tightly | a) the base nut is tight b) the lubrication is not good | a) properly loosen the base nut b) properly add lubricant |
handle switch is tight | spool contains impurities | removing the spool cleaning |
the hot and cold water positions are opposite | spool or inlet hose installation is reversed
| adjust the spool or inlet hose |